Al for Model Number WTW6700TW1 I have a WTW6700TW1 washer. When I start it, after a couple of seconds, it stops and displays an "F1" error code. At this point, I hit the "Power" button to turn it off. I hit it again to turn it on; followed by the "Start" button. After a second or two, it stops and displays "F1". I repeat this cycle up to 10 times. At some point the machine fills and the wash completes. However, it again fails at the rinse cycle. I then power it off again, turn it to the "Rinse & Spin" position and repeat the power and start cycle until the "F1" error fails to interrupt. Does this suggest a part that needs to be replaced or an adjustment that should be made? Thanks for your help.
Answer Al, F then 1 flashes when the control detects an out of range pressure signal. Check pressure hose connection from tub to machine/motor control. Is hose pinched, kinked, plugged or leaking air? If F then 1 repeats numerous times after POWER is pressed and the pressure hose connection is not pinched or kinked, replace the machine/motor control. Read More... Answered by AppliancePartsPros.com | Monday, March 28, 2022