Ken for Model Number kuds30Ixss-4 I have replaced the control board twice already. Recently we realized the dishes in the top rack are not being cleaned as if no water at all is reaching them and the dishes in the bottom rack are barely cleaned. After a complete cycle we also noticed that although the soap dispenser is open, that some detergent remains inside the dispenser and there remains detergent on the door itself and on the base of the dishwasher, as if very little water is circulating during a run. I replaced the water inlet valve but problem persists. I took the arms apart and all the assemblies checking for clogged holes etc, but all is clean, unclogged. When it runs, it appears from the sounds that it goes through all its cycles (I never opened the door during the cycles), no loud grinding noise, plates are hot and unit even steamy when opened at end of cycle. Is the issue my motor?
Answer Hello Ken, This sounds like the chopper W10083957V has an issue. I would check it and if no problem exists, replace the sump and motor assembly WPW10780877. Read More... Answered by AppliancePartsPros.com | Tuesday, January 26, 2016