Richard for Model Number Kenmore (Whirlpool) 665.13752K602 I've actually rebuilt the circulation pump motor WPW10757217. The front bearing went out and caused the impellor seal to start leaking on itself or the seal went out and caused the bearing to go bad. It was leaking very slowly on itself for a long time, I noticed oxidation on the front of the pump motor housing around the frozen bearing, so I don't know which came first. I checked the inside of the motor and nothing was damaged. Replaced the front and rear bearings, circlips, and impellor seals. I really had to work the old bearing outer race out of the front motor housing as I did the inner race off of the front end of the shaft with a puller/press, oil, and heat. So in doing this I removed the circulation pump capacitor WPW10334457. I don't know which of the two wires goes where. The capacitor has a 1 or 2 mark above each male connector. There are two capacitor wires, one blue and one yellow. Which male connector is the blue to be attached to and which one to the yellow. There is no tech service sheet on the dishwasher. I did finally find a tech sheet, W10130990, for the dishwasher after a long search on the internet but it is for a few models and wiring colors on the shematics are different.
Answer Richard, The blue will go to the number 1 and the yellow will go to the number 2. Read More... Answered by AppliancePartsPros.com | Thursday, September 22, 2016