Customer Questions and Answers for Drive Motor (Three-Speed) by Whirlpool

Joe, Here are the basic access information for your style washer, make sure you unplug the power cord first, " Servicing Components in the Console 1. Remove the two Phillips-head screws securing the front corners of the console to the washer top. the two screws could also be located on the back side of the end caps. 2. Tip the console back on the hinges that secure the top of the console to the washer back. ACCESSING COMPONENTS INSIDE THE WASHER CABINET Components inside the washer cabinet can be accessed by completely removing the outer cabinet as one unit. 1. Remove the console mounting screws and tilt the console into the service position. 2. Unplug the lid switch harness connector from the receptacle in the washer top. 3. Remove the cabinet mounting clips by placing the flat blade of a screwdriver in the clip and press down and towards the front to release the clip. 4. Remove the cabinet by tilting it forward and pulling it away from the washer. 5. The rear panel can be tilted back for additional access to components at rear of machine by twisting the rear panel support 90°. and then tilting the rear panel back." I think, that will get you into the cabinet, and you'll be able to check and diagnose the motor aand pump assembly, easily from there. But make sure you check the lid switch and wiring when you lift the control panel assembly. Thanks and Good Luck