Customer Questions and Answers for Rotor Position Sensor by Whirlpool

Hello Tim, You should run the diagnostic test mode and pull any fault codes that are stored in the control. This will point you in the right direction for a proper repair. The procedure is as follows: 1. Be sure the washer is in standby mode (plugged in with all indicators off) or in setting mode (plugged in and power up just before running a cycle). 2. Select any one button (except POWER/CANCEL and START/PAUSE) and follow the steps below, using the same button: a. Press/hold 3 seconds. b. Release for 3 seconds. c. Press/hold 3 seconds. d. Release for 3 seconds. e. Press/hold 3 seconds. If this test mode has been entered successfully, all indicators on the console are illuminated for 5 seconds with 8:88 showing in the Estimated Time Remaining three-digit display. If indicators do not display as described above, the press/hold/release procedure above may not have been performed within the time frame necessary for successful entry. Repeat step 2 to ensure this was not the cause. 3. The test sequence continues by checking for saved fault codes. If there are no saved fault codes, all indicators on the console will momentarily turn off, then turn back on with 8:88 displayed. After 5 seconds, the Automatic test begins.