Tim for Model Number PAV3100AWW The small rubber hose that connects to the back of the tub that connects to the pressure switch came loose, so washer would not stop filling and the tub was leaking. Reconnected the hose and clip. Washer runs fine through the whole cycle, except it will not spin at all. It does agitate fine though. During the spin cycle, the motor runs, pulley and belt turn, but tub does not. Suspect that something got wet and shorted that will not allow the transmission to engage the tub or the brake to disengage during the spin cycle. Any thoughts? Where do I start.
Answer Tim, The issue with the unit would either be a faulty thrust bearing 12002213 not pushing up on the brake WP35-6714 to release it or will be a brake that is stuck and not releasing. You will want to check both of these. Read More... Answered by AppliancePartsPros.com | Friday, July 11, 2014