Charles J. for Model Number KEMC378KSS02 I need to replace the door torsion springs for the upper microwave oven of this combination. What is the correct part number for the LH and RH springs? I found P/N 4451008 (AP3046481) but it is listed as a LH spring, and I would like to replace both springs once I get the oven pulled out from the wall to drop the door. I also need to replace the light in this oven. I ordered the bulb, but it is not clear how to change it out, since it does not seem accessible from inside the oven cavity.
Answer Charles, the right hand is part number WP4452396 and the left hand is part number AP3137553]. The microwave oven bulb is part number WPW10440740. Here is the installation instructions. Hope they help. Thanks! 1. Disconnect the electrical power to the microwave/oven combination. 2. Remove the microwave oven from the oven cabinet) a) Unclip the wire retainer and remove it. b) Remove the lamp from the holder and remove the wires from the harness." Quite often, you don't have to remove the microwave. You can usually access and change the cavity light by removing the control panel. " 1. Disconnect the electrical power to the microwave/oven combination. 2. Open the lower oven door. 3. Remove the bottom screw from each of the two side trim pieces . 4. To remove the side trim, pull the bottom out approximately 2?, and slide the top down to free it from the control panel. 5. Remove the screws from the oven control 6. To remove the oven control panel, pull it out at the bottom, and lift and unhook it from the oven cabinet support at the top. 7. Pull the ground clip on the end of the green wire from the edge of the metal panel, and disconnect the wire connectors from the board. Set the panel face down on a padded surface to protect the finish. Read More... Answered by AppliancePartsPros.com | Tuesday, October 1, 2013