Customer Questions and Answers for Spud - Orifice by Whirlpool

Hello Jim, If you have the owners manual and installation guide, the instructions for the conversion are in the installation guide and the fine tune of the flame is covered in the owners manual. If you do not have these and you would like a copy, please re-post with an e-mail address we can send it to you in and we will get it right out to you. It looks like this model has no conversion kit because the changeover is simply a case of adjustment. The basic instructions read as follows: Use a wrench to remove the Pressure Regulator cap from the top by turning counter-clockwise. Turn the cap over so the hole end is up. Replace the cap and gasket on the regulator. Do not remove the pressure regulator. To change over the cooktop burners, turn the orifice hoods down until snug against pin (about 2 1/2 turns). DO NOT OVERTIGHTEN. Replace maintop. To changeover the oven burner, remove the oven racks and the screws at the rear of oven bottom. Pull oven bottom rear up and remove front of oven bottom from the oven frame. remove it and the baffle from underneath it. Turn the orifice hood down until down against pin. DO NOT OVERTIGHTEN. The burner flame should be 1 inch long when the air shutter is correctly adjusted. The air shutter slides to close or open by loosening the screw.