Skip to Content
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • lovely images 15 million satisfied customers
  • boxes images Over 2.1 Million Parts In Stock
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store

Customer Questions and Answers for Spud - Orifice by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM9358773
Manufacturer Part Number: 814547

L.P. kit.

More

Questions & Answers

For Whirlpool Spud - Orifice (Part Number: OEM9358773)

1 Answer

Scott, the LP conversion kit listed for your model is part number 814547. You may go to www.whirlpool.com and click on Customer Support, Manuals & Literature. Once you are on Manuals & Literature you may enter in your model number and view the available owners manual and installation manuals for your unit. Hope this helps. Thanks!

Read More...

1 Answer

Hello Jim, If you have the owners manual and installation guide, the instructions for the conversion are in the installation guide and the fine tune of the flame is covered in the owners manual. If you do not have these and you would like a copy, please re-post with an e-mail address we can send it to you in and we will get it right out to you. It looks like this model has no conversion kit because the changeover is simply a case of adjustment. The basic instructions read as follows: Use a wrench to remove the Pressure Regulator cap from the top by turning counter-clockwise. Turn the cap over so the hole end is up. Replace the cap and gasket on the regulator. Do not remove the pressure regulator. To change over the cooktop burners, turn the orifice hoods down until snug against pin (about 2 1/2 turns). DO NOT OVERTIGHTEN. Replace maintop. To changeover the oven burner, remove the oven racks and the screws at the rear of oven bottom. Pull oven bottom rear up and remove front of oven bottom from the oven frame. remove it and the baffle from underneath it. Turn the orifice hood down until down against pin. DO NOT OVERTIGHTEN. The burner flame should be 1 inch long when the air shutter is correctly adjusted. The air shutter slides to close or open by loosening the screw.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • boxes images Over 2.1 Million Parts In Stock
  • time delivery images 2 Day Quick Delivery!
  • box-refresh images 365 Day Return Policy!
  • headphone imagesFree Tech Support!
  • google images Google Trusted Store