Casey D. for Model Number Wed9200sq1 I have a Whirlpool duet front loader dryer it quit working I would hit the start button and the light to the sensing would come on but it wouldn't do anything so I looked it up on the internet and it said it was the thermal fuse so I got one put it on and did one load and did the same thing. What else could it be?
Answer Hello Casey, You will need to activate the diagnostic test mode to read any saved fault codes. These will point you to the problem with the unit. ACTIVATING THE DIAGNOSTIC TEST MODE: 1. Be sure the dryer is in standby mode (plugged in with all indicators off, or with only the Done indicator on). 2. Select any one button (except Pause/Cancel and Controls Lock/Unlock) and follow the steps below, using the same button (remember the button): Press/hold 2 seconds. Release for 2 seconds. Press/hold 2 seconds. Release for 2 seconds. Press/hold 2 seconds 3. If this test mode has been entered successfully, all indicators on the console are illuminated for 5 seconds with 8:88 showing in the Estimated Time Remaining three-digit display. If there are no saved fault codes or active fault codes, all indicators on the console will momentarily turn off, then stay on with 8:88 displayed. Continue with diagnostics. 4. If entry into Diagnostic Test Mode is unsuccessful, choose a different button (except Pause Cancel and Controls Lock/Unlock) and repeat step 2. Read More... Answered by AppliancePartsPros.com | Saturday, September 8, 2018