Customer Questions and Answers for Control Board by Whirlpool

Hello Dwayne, 1. Unplug washer or disconnect power. 2. Turn off the water supply to the washer. 3. Remove the three T-20 hex-head Torx screws from the top cover of the washer. 4. Pull back on the cover and release the tabs in the console from the slots in the cover, then lift the cover off the unit. 5. To remove the console: a) Pull out and disconnect cable connector UI8 from the central control unit. b) Remove the cable wires from the two central control unit clips. c) Pull the detergent dispenser drawer out as far as it will go, then press down on the release tab, and remove the drawer from the unit. d) Remove the two screws at the recessed hole and bottom of the console. e) Lift the top edge of the console and unhook it from the holder clips. f) Press the locking tab on the right rear side of the console inward, and remove the console. 6. To remove the touchpad/LED assembly: a) Pull the selector knob off the switch shaft. b) Press the seven console locking tabs, and unsnap the touchpad/LED assembly, then lift the assembly from the console and remove it. REMOVING THE CENTRAL CONTROL UNIT Pull the wire connectors off the edges of the central control unit circuit board (see the top right photo). When you pull an edge connector off the board, first pry the locking tab away from the connector with a small screwdriver blade to release it. Slide the hooked ends of the two wire clamps off the locking tabs, and remove the wires from the clamps. Pry up on the locking tab, and push the central control unit (CCU) toward the rear of the washer as far as it will go, and remove the CCU tabs from the keyhole slots in the chassis. REASSEMBLY NOTE: Make sure that you seat the connectors firmly onto the circuit board, and that they lock securely into place.