Customer Questions and Answers for Water Inlet Valve Assembly by Whirlpool

Hello Steve, It looks like your model number is missing the 1st three numbers. I searched "110" 29522801 and found your model so you may want to verify that. Your water valve WPW10144820 is accessible from the front of the machine not the back. If you'd like to see how the front cabinet comes off, check out the video shown on replacing your drain pump [3363394]. Hope this helps! http://www.appliancepartspros.com/whirlpool-whirlpool-direct-drive-3363394-ap2907492.html Here are step by step instructions as well. 1. Unplug washer or disconnect power. (also disconnect the fill hoses) 2. Slide a putty knife under the right or left corner of the control panel. Lift the corner of the panel and push back on the knife blade to release the clip. Repeat the procedure for the other clip. 3. Rotate the control panel and position it back out of the way. 4.Lift the locking tab, and disconnect the main harness from the lid switch connector. 5.Remove the 5/16? hex-head screw from the green ground wire on the lid switch. Lift the washer lid so it is straight up. Release the locking tab and pull the lid switch up and out of the cabinet top opening. 6. Use a screwdriver and unclip the left and right cabinet spring clips from the cabinet top. 7. Rotate the cabinet up in the back and slide forward so you can access the top of the tub,and set the cabinet aside." You now have access to the fill valve assembly Use a flat blade screw driver and remove the plastic mounting pin, and disconnect the tabs in the assembly from the slots in the cabinet back, disconnect the wires and reverse the procedure to install the new valve assembly.