Parts for Thermador PRD48JDSGU/09: Blower / Door Latch Parts

Oven won't heat or element burned out? This high-temperature cut-out fuse interrupts power when temperatures exceed safe levels. Often fails with elements.

Fix range burners not heating or electrical issues with this terminal block. Common repair for failed ignition or power connections on gas ranges.

Fixes ranges with uneven baking or slow cooking in convection mode. This motor circulates hot air throughout the oven cavity for even heat distribution.

Fix error code 43 with this range cooling fan. Simple 30-minute repair—pull range out, remove back plate, swap fan, reassemble. Clear instructions.

Range oven door won't lock during self-clean cycle? This door lock assembly ensures safe operation. A moderately challenging fix with basic tools.

Fix an oven light that won't turn on or a self-clean cycle that won't start. This door switch monitors door position for safety and lighting.

Outer leg cover for gas ranges. This decorative trim piece covers the exterior of the range leg. Replace if cracked, chipped, or damaged for a clean look.

Rubber foot that attaches to the bottom of your gas range to provide stability and prevent floor scratches. Replace if cracked, worn, or missing.

Replacement bolt for gas ranges. Secures components and panels in place. Order a new bolt if yours is stripped, corroded, missing, or damaged.

Black plastic cover that fits over the bottom corner leg of your range. Sold individually. Replace if cracked, broken, or missing for a complete look.

Range not responding to controls or remote commands? This wireless signal receiver module restores communication between your interface and control board.

Oven door seal creates airtight closure to retain heat and improve cooking efficiency. Replace if torn, hardened, or heat escapes around door edges.

This adapter is a replacement connection piece that restores a secure fit between mating components, helping stop leaks and keep plumbing or internal assemblies aligned for reliable operation. What it does:

• Provides a precise mating surface to join two parts that no longer fit securely
• Restores proper alignment to reduce stress on hoses or fittings
• Helps stop symptoms like leaks, loose or wobbly connections, and poor sealing
• Designed to match the OEM geometry for a correct fit when replacing a worn or damaged adapter

• One replacement adapter

• Turn off power and shut off water supply before beginning installation
• Remove only the damaged adapter and replace with the new part; do not force or modify parts
• Hand-start fasteners or fittings, then tighten to OEM or plumbing torque recommendations; check for leaks after restoring supply

Replacement screw for gas ranges, ranges, and wall ovens. Used to secure panels, brackets, or components during installation and repairs. Order now.