Parts for Frigidaire DGA500A1W: 05 - Blower & Heater Housing Components Parts

Mounting screw for dryer assembly and panel installation. Replace if stripped, missing, or corroded. Essential hardware for secure component attachment.

This small retainer clip secures trim and components to the appliance chassis, keeping panels and assemblies properly seated for quiet, reliable operation. It's a simple replacement that restores secure fastening where the original clip has broken or worn. What it does

• Holds panels, trim pieces, or small assemblies in place to prevent looseness and rattling
• Replaces a broken, bent, or missing clip that allows parts to shift during use
• Helps maintain proper alignment of adjacent components for smooth operation
• Works where a firm, non-permanent fastener is required

• One retainer clip

• Disconnect power before servicing any appliance to avoid shock or injury
• Access the clip location by removing the appropriate trim or panel per your model's service instructions
• Use needle-nose pliers or a flat screwdriver to remove the old clip and press the new clip into place until it seats securely

Sems screw for washer assembly. Secures internal components and panels. Replace if missing, stripped, or damaged during appliance repair or maintenance.

Mounting screw for dryer assembly and panel installation. Replace if stripped, missing, or corroded. Essential hardware for secure component attachment.

Mounting screw for dryer assembly and panel installation. Replace if stripped, missing, or corroded. Essential hardware for secure component attachment.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Mounting screw for dryer assembly and panel installation. Replace if stripped, missing, or corroded. Essential hardware for secure component attachment.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This lock washer secures fasteners and helps keep appliance panels and components from loosening during normal use, restoring a stable connection and reducing rattles or movement. What it does

• Grips under a screw or bolt to resist loosening from vibration and thermal cycling
• Helps keep panels, brackets, and small components securely fastened
• Commonly used where a screw or bolt must stay tight despite vibration
• Can reduce rattling noises and intermittent loose-part symptoms

• Disconnect power to the appliance before beginning any repair
• Replace with the same type and orientation of washer for proper locking action
• Use appropriately sized screw or bolt; do not mix with mismatched hardware
• Hand-start fasteners, then tighten to snug fit—avoid over-tightening which can deform the washer

Sound dampening insulation for dryers. Installs inside cabinet to reduce noise and vibration. Replace if torn, missing, or deteriorated over time.