Parts for Frigidaire 30-4952-00-01: 05 - Body Parts

This factory replacement oven probe kit lets your range or wall oven sense temperature during probe-cook cycles. It restores reliable probe detection and accurate temperature feedback to help your control end cooking at the right time.

• Senses temperature and relays readings to the electronic control during probe-assisted cooking
• Supports probe-cook features that stop or hold when the target temperature is reached
• Common symptoms: "PROBE" error or no detection, erratic/stuck readings, or visible damage/corrosion on the probe or receptacle
• Replaces heat-damaged or worn probe components to ensure consistent contact and accurate feedback

• Disconnect power to the appliance before servicing
• Access may require removing the oven from the cabinet; route wiring along the factory path and away from hot surfaces
• Handle connectors and sensor tip carefully; do not kink the cable
• After installation, run a brief probe test per the user/service manual to confirm proper operation

Note: ONE screw only, order as needed.

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

This part has been discontinued by the manufacturer and is no longer available.