Parts for Ge GTUP240EM4WW: Cabinet (3) Parts

Size: 8 - 18 ab.

A push-on speed nut that secures panels, trim, or lightweight components to studs and shafts, restoring a tight, rattle-free fit. Ideal when the original retaining nut is damaged or missing. What it does

• Climbs and locks onto a threaded stud or shaft to hold panels and assemblies in place
• Prevents loosening and vibration that can cause rattles or misalignment
• Common replacement when the original nut is stripped, cracked, or no longer grips

• Disconnect power and water (if applicable) before servicing the appliance
• Press the nut firmly onto the stud or shaft until fully seated; use pliers for tight fits if needed
• Replace any damaged mating hardware for a secure repair

This is a #8-18 by 5/8-inch Torq II-head screw used to secure appliance panels and components. It provides a reliable fastener option when replacing stripped or missing screws to restore proper fit and reduce vibration or rattling. What it does:

• Secures trim, panels, brackets or small components to appliance frames
• Restores proper alignment and reduces noise from loose parts
• Replaces worn, stripped, or missing fasteners to prevent further damage
• Compatible where an 8-18 thread and 5/8" length with a Torq II-style head are specified

• One screw

• Use the correct Torq II driver bit to avoid cam-out or head damage
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• If replacing rusted or stripped screws, inspect mating threads and replace as needed
• Disconnect power and follow appliance safety instructions before servicing

This lid actuator engages the washer's lid switch or lock when the lid closes, signaling the control that it's safe to run. Replacing a worn or broken actuator restores reliable lid detection for wash and spin cycles.

• Engages the lid switch/lock when the lid is closed
• Signals the control to allow the washer to start and spin
• A damaged or missing actuator can lead to "lid open" errors
• Common symptoms include won't start, won't spin, or lid lock light flashing

• Disconnect power before servicing
• Access the lid switch/lock area; remove the failed actuator
• Install the new actuator, aligning it to the original mounting points; reuse existing hardware
• Close up and test lid detection before running a full cycle