Parts for DE05-US0: Cabinet Assembly Parts

Adjustable

Front bracket and leveling screw assembly.

Rear bracket and leveling screw assembly.

This exhaust cover plate seals an unused dryer vent opening on the cabinet to prevent air leaks and lint escape. Replacing a missing or damaged cover helps maintain proper airflow and support efficient drying performance. What it does:

• Covers and seals an unused exhaust port on the dryer cabinet
• Helps maintain correct airflow through the exhaust duct
• Helps keep lint and warm, moist air from leaking into the laundry area
• Replace if the original is missing, cracked, loose, or you notice lint/air leakage or longer dry times

• 1 exhaust cover plate

• Disconnect power; for gas dryers, turn off the gas supply
• Locate the unused exhaust opening (rear, side, or bottom—depending on vent configuration)
• Position the plate over the opening and secure using the existing hardware; do not overtighten
• Restore power and verify proper airflow at the active vent

A small screw-mounted bumper that cushions and supports moving parts to reduce noise, vibration and metal-to-metal contact. Replacing a worn bumper restores quiet door/drawer operation and helps maintain proper alignment. What it does:

• Cushions impact between components to prevent chipping or metal wear
• Dampens vibration and reduces rattling or banging noises
• Helps keep doors or drawers aligned and closing smoothly
• Prevents direct metal-to-metal contact that can cause scratching or further damage

• Turn off and unplug the appliance before attempting any repair
• Remove the defective bumper and install replacement at the same mounting hole; secure with the supplied or original screw
• Do not overtighten the screw—compressing the bumper can reduce its effectiveness

Includes 12 screws. Size: 8-18 ab.