Parts for DG60FA2-96979: Cabinet Parts

If your dryer timer knob is broken, cracked, or won't turn properly, this timer knob assembly restores easy control over cycle selection and timing.

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Mounting screw for dryer drum support and internal components. Replaces lost, stripped, or damaged screws during repairs. Package of 12 screws included.

Protective plastic housing that secures the dryer control board. Replace if cracked, broken, or missing to properly support and shield electronics.

Fix dryer cycles that won't advance or start properly with this timer cycle selector. Controls program settings and timed functions. Restores correct sequencing.

Replacement mounting screw for dryer front panel assembly. Secures front panel to cabinet. Needed when original screw is stripped, missing, or lost.

This heat shield protects surrounding oven components by deflecting high temperatures away from sensitive parts, helping prevent heat damage and extending appliance life. Fits behind oven liners where heat needs routing or isolation. What it does:

• Deflects and redirects radiant heat away from control panels and wiring
• Protects nearby insulation, wiring, and electronic components from overheating
• Helps reduce heat transfer to adjacent cabinetry and structural parts
• Commonly replaced when warped, cracked, or corroded, or when heat-related component failures occur

• Heat shield

• Disconnect power and let the appliance fully cool before starting work
• Follow OEM service manual for correct location and fastener torque; use original mounting hardware
• Inspect adjacent insulation and components; replace any heat-damaged parts as needed

Adjustable leveling leg that installs on the bottom of your dryer to stabilize and level the unit. Replace missing, broken, or worn legs. Easy DIY.

Front leveling leg bracket for dryers. Secures the adjustable front leg to the dryer base. Replace if cracked, bent, or broken to restore stability.