Parts for Frigidaire FAS186T2A1: 02 - Cabinet Parts

Structural mounting bracket for air conditioner units. Replaces cracked, broken, or damaged brackets that secure components. Direct fit replacement part.

This top rail seal fits over the upper door rail to help form a tight closure and reduce air leaks, improving cooling performance and efficiency. It replaces worn or damaged sealing on the door top rail. What it does:

• Seals the top edge of the door rail to maintain an airtight cabinet seal
• Helps prevent warm air and moisture from entering the refrigerator or freezer
• Reduces frost build-up and helps maintain consistent internal temperature
• Commonly replaced when the seal is cracked, torn, deformed, or no longer seats properly

• Inspect the door and rail for damage before installing; replace any broken mounting clips if needed
• Remove the old seal carefully to avoid damaging the door finish; clean the mounting surface before installing the new seal
• Press the seal evenly into the rail channel until fully seated; some models may require gentle warming to aid fitment
• Always unplug the appliance or disconnect power before starting repairs

Accordion retainer for air conditioners and heat pumps. Secures accordion panels on unit sides. Replace if cracked, broken, or missing to restore proper fit.

Hardware kit for mounting air conditioner components. Includes necessary screws, bolts, and fasteners. Replace missing or damaged mounting hardware.

Front panel clip for air conditioners. Secures the front cover to the unit housing. Replace if cracked, broken, or missing to properly hold the door in place.

A front mounting bracket that secures the appliance's front panel or trim, helping keep panels aligned and stable for proper fit and operation. Durable replacement for worn or damaged front bracket hardware. What it does:

• Provides a secure attachment point for the front panel or trim to the appliance cabinet
• Keeps the front panel aligned to prevent gaps or rubbing during use
• Reduces vibration and rattling caused by a loose or broken bracket
• Helps restore correct door/panel fit and appearance

• Disconnect power to the appliance before starting any repair
• Use basic hand tools; support panels to avoid damage while removing fasteners
• Reinstall fasteners to manufacturer torque; check panel alignment after installation

Mounting support kit for air conditioners and heat pumps. Secures unit to mounting surface. Replace if brackets are bent, rusted, or damaged.

This flat washer provides a smooth, stable bearing surface for a fastener, helping distribute load and protect the mating surface. Use it when a worn or missing washer causes loose or unstable connections. What it does:

• Distributes clamping force across a wider area to prevent pull-through
• Protects finishes and reduces metal-on-metal wear under bolt heads or nuts
• Helps reduce loosening and vibration-related noise in assemblies
• Commonly used wherever a fastener needs a stable bearing surface

• Turn off and unplug the appliance before performing any repairs
• Remove surrounding panels or components as needed to access the fastener
• Replace the washer with the same size and orientation as the original
• Replace damaged or corroded fasteners with matching hardware

Hex flange nut with 10-32 thread secures components in appliances. Replace if stripped, missing, or damaged. Flange provides broader bearing surface.