Parts for Lg LROFC0605V/00: Case Parts

This replacement door basket restores interior storage on the refrigerator door, keeping bottles and small items secure and accessible. Fits the matching LG door opening and restores original organization and containment. What it does:

• Holds bottles, jars and small food items to free up shelf space inside the fridge
• Replaces cracked, warped or broken door bins that allow items to fall or shift
• Restores proper containment to prevent spills and improve organization
• Matches OEM fit and mounting locations for a secure install when the correct part is used

• Use basic hand tools; remove existing bin by lifting or unclipping per your model's procedure
• Handle carefully to avoid scratching or chipping plastic during installation
• Keep away from open flames and avoid excessive force when seating clips

This overload protector is a direct-replacement electrical safety device that helps protect the compressor motor from overheating and overcurrent. It trips the circuit when the compressor draws excessive current, helping prevent damage and allowing normal operation once cooled. What it does:

• Detects excessive current or high temperature at the compressor and interrupts power to prevent motor damage.
• Helps stop hard-starting or repeated short-run cycles caused by motor overload.
• Commonly linked to symptoms such as a refrigerator or freezer that hums or clicks, runs briefly then stops, or fails to maintain proper cooling.
• Works with the start components to ensure reliable compressor startup and protect against electrical stress.

• Always unplug the appliance or disconnect power at the breaker before servicing.
• Handle compressor terminals and wiring carefully; avoid bending or damaging terminal tabs.
• Replace with the identical part number or OEM-specified protector to ensure correct fit and electrical ratings.
• After installation, restore power and observe the appliance through one full start/stop cycle to confirm normal operation.

This small stopper installs in the refrigerator to limit the travel of a moving component and keep it securely in place. Replacing a broken or missing stopper prevents over-extension and helps maintain smooth, aligned operation.

• Limits the range of motion for a door, bin, or drawer to prevent over-opening or accidental removal
• Helps keep interior components aligned and operating smoothly
• Replace if cracked, missing, or deformed
• Common symptoms: drawer or bin slides out too far, door swings past normal range, or a broken plastic stop is found

• Disconnect power before servicing; remove or support the affected bin/drawer/door
• Note the old stopper's orientation and location before removal
• Transfer and reuse any original screws or clips if applicable
• Snap or fasten the new stopper in place and test for smooth movement

The Drier Assembly is an OEM part for LG refrigerators. This part is responsible for removing moisture and contaminants from the refrigerant. This ensures that the refrigerant circulates effectively and efficiently, preventing damage to other components and maintaining the refrigerator's cooling performance.

Causes of a bad Drier Assembly can include contamination from moisture entering the refrigerant lines, blockages from debris or particulates, and general wear and tear over time that reduces its effectiveness.

Symptoms of a bad Drier Assembly include:

• Reduced cooling efficiency or warm refrigerator temperatures
• Unusual noises from the refrigeration system
• The compressor running continuously or cycling frequently
• Frost buildup on the evaporator coils due to improper refrigerant flow

This OEM LG part is also compatible with Sears/Kenmore models.

This power control board assembly replaces the appliance's main electronic control module, restoring reliable power distribution and control of cycles and user interface functions. It's a direct-replacement electronic control used in affected LG appliances. What it does:

• Regulates and distributes electrical power to control circuits and components
• Interfaces with user controls and sensors to manage cycle signals
• Helps resolve symptoms such as no power to the control panel, unresponsive controls, erratic or stopped cycles, and display or communication errors
• Contains the PCB and housing needed for a like-for-like replacement

• Disconnect power to the appliance before servicing to prevent shock or damage
• Handle the PCB by the edges and avoid touching components; use anti-static precautions
• Replacement may require removing access panels and unplugging wire harness connectors; keep track of connector locations