Parts for Frigidaire FAH12EM2T1: 09 - Compressor Parts

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

This replacement terminal cover protects the appliance's power terminal block and wiring from accidental contact and debris, restoring a safe enclosure for the live electrical connections. What it does:

• Protects the terminal block and wiring from accidental contact, dust and debris
• Helps prevent arcing, sparks or shorting caused by exposed terminals
• Secures the routing area around power connections for safer operation
• Useful when original cover is cracked, melted, missing or shows burn marks

• Always disconnect power at the breaker or unplug the appliance before servicing
• Remove access panel or back panel to reach the terminal block; reinstall cover so it fully encloses the terminals
• Use appropriate fasteners if required; ensure all wire terminals are tight and positioned before replacing the cover
• If wiring or the terminal block shows damage or corrosion, replace or repair those components before restoring power

This base tray is the OEM replacement panel that supports internal components and helps contain spills for proper drainage and appliance stability. Replacing a damaged tray restores a secure interior fit and reduces leaks or debris buildup. What it does:

• Provides a stable support surface for lower interior components and accessories
• Channels or contains minor spills to help prevent water from reaching electronics or cabinet floor
• Restores proper alignment and fit when original tray is cracked, warped, or broken
• Helps eliminate rattles or movement caused by a damaged or loose base

• Base tray as shown

• Disconnect power to the appliance before starting any repair
• Remove surrounding panels or components per OEM instructions to access the tray
• Inspect mounting tabs and seals; align tray carefully and avoid forcing it into place
• Replace with manufacturer-specified hardware and test for leaks after reassembly

A small metal mounting screw used to secure appliance panels and internal components. Simple replacement that restores proper fit and reduces rattling or loose parts when the original fastener is missing or damaged. What it does

• Secures panels, brackets, or trim pieces to the appliance chassis
• Holds internal components in place to maintain alignment and function
• Helps prevent vibration noise and movement from loose parts
• Suitable where the OEM listed screw size and thread match the original

• Disconnect power and water before servicing
• Use the correct screwdriver or driver bit to avoid stripping the head
• Start threads by hand to prevent cross-threading; tighten until snug—do not overtighten
• Keep any removed screws organized to ensure correct reassembly