Parts for Thermador PD484GED01: Connections Parts

This gas pressure regulator controls and stabilizes incoming supply pressure to the appliance manifold, helping ensure consistent burner flames and reliable ignition. Replace if the original regulator is sticking or no longer maintaining correct pressure.

• Regulates incoming gas to the appliance's rated manifold pressure
• Helps maintain even flame height and proper combustion
• Supports reliable burner ignition and reduces flame-out from pressure swings
• Common symptoms include weak or uneven flames, yellow tipping, burners not lighting or not staying lit, or flames that are too high

• Disconnect electrical power and shut off the gas supply before servicing
• Observe the flow-direction arrow; install with outlet toward the appliance manifold
• Use approved gas-rated thread sealant on male threads only and leak-test all joints with a non-corrosive solution after installation

The Tube is a genuine OEM part for Bosch ranges. This part facilitates the delivery of gas to the surface burners, ensuring that they operate efficiently and safely. 

Over time, the Tube may exhibit signs of wear or damage due to rusting, physical damage or natural degradation.

Symptoms indicating the need for a new Tube include:

• A decrease in burner flame quality or uneven flames, which can affect cooking performance.
• The smell of gas in the vicinity of the range, signaling a potential gas leak.
• Difficulty igniting the surface burners or experiencing incomplete combustion.

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The Tube is an OEM part for Bosch gas ranges. It is a hollow metal tube that sits beneath each gas burner on the cooktop and connects the burner to the gas valve and manifold.

Causes of a bad tube include normal wear and tear over extended use. Gas burns at high temperatures and the tubes are constantly exposed to heat which can weaken the metal over time. Accidental damage during cleaning is also possible.

Symptoms of a bad tube include:

• Burners that will not ignite or light inconsistently
• Weak, small flames rather than strong blue flames
• Burners that emit an unusual smell when operating
• Uneven or abnormal cooking temperatures from the burner

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Replacement water inlet valve that controls an appliance's incoming water flow for reliable fill and cycle operation. Replacing a faulty valve can stop no-fill, slow-fill, or continuous-fill issues and restore normal performance. What it does:

• Opens and closes to regulate water entering the appliance during fill cycles.
• Helps ensure correct water levels for proper washing or rinsing.
• Common symptom fixer for appliances that won't fill, fill slowly, or keep filling.
• May cause visible leaks at the valve or trigger fill-related fault behavior if failed.

• Turn off power and shut off the water supply before starting any work.
• Open a cycle or relieve pressure to drain residual water before removing the old valve.
• Inspect and replace any worn seals or inlet hoses when installing the new valve.
• Follow the appliance service manual for specific removal/installation steps.