Parts for Ge UCG1520N0SS: Container Parts

This stainless steel door assembly replaces a damaged or worn outer oven/microwave door to restore appearance and safe sealing. It provides the finished exterior panel and top trim for a clean, professional look. What it does:

• Replaces a dented, scratched or corroded outer door panel to improve appliance appearance
• Restores the door's proper alignment and helps the door close securely when combined with intact hinges and latches
• Replaces a cracked or warped exterior panel that may allow drafts or heat loss
• Useful when cosmetic damage is concentrated on the outer door surface

• One stainless steel outer door assembly

• Disconnect power to the appliance before beginning any repair and allow surfaces to cool
• Installation typically requires removing interior trim and the door from its hinges; keep screws and small parts organized
• Handle the stainless panel carefully to avoid scratches; use protective gloves and a soft surface

This foot pedal assembly lets you operate the appliance hands-free by actuating the pedal switch, restoring reliable on/off control when the original pedal is worn, loose, or unresponsive. Designed as a direct replacement part. What it does:

• Acts as the cabinet-mounted pedal switch actuator to start and stop the appliance without using your hands.
• Replaces worn, cracked or sticking pedals that cause intermittent or no response.
• Restores solid mechanical contact so the appliance responds consistently when the pedal is pressed.
• Helps eliminate the need to reach for the main control switch when hands-free operation is preferred.

• One foot pedal assembly

• Disconnect power to the appliance before beginning any work.
• Basic hand tools typically required; mounting hardware may be needed if not reusable from the original.
• Route and secure the pedal cable to avoid pinch points; test operation after reconnecting power.

The Drawer Roller Asm is an OEM component specifically designed for GE Waste Compactors. This Drawer Roller Asm is responsible for safely guiding the compactor drawer in and out. By assisting the smooth opening and closing of the drawer, it helps reduce strain on the entire compactor system.

Causes of bad rollers can include excessive use over time, improper loading that puts undue stress on the rollers, or damage from impact or pinching. 

Symptoms of bad rollers include: 

• Difficulty opening or closing the compactor drawer 
• Excessive noise or grinding sounds when moving the drawer
• The drawer not sliding freely and securely on its rollers

This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore trash compactor models.

This drawer assembly restores a refrigerator drawer that opens and closes using a built-in black foot pedal, providing the drawer support and pedal mechanism needed for smooth operation and user convenience. What it does:

• Replaces the drawer support and pedal mechanism so the drawer opens and closes reliably
• Restores pedal actuation when the foot pedal no longer engages or is broken
• Stops drawer from sagging, sticking, or falling out of alignment
• Helps eliminate noise or grinding from a damaged or worn drawer mechanism

• Disconnect power to the appliance before beginning any work to avoid electrical hazard.
• Use basic hand tools; support the drawer while removing and installing the assembly to avoid dropping.
• Align slides and mounting tabs carefully; do not force components into place.