Parts for Frigidaire FGC6X8XESA: 02 - Control Panel / Main Top Parts

This replacement burner pan restores the cooktop surface under a surface heating element, catching spills and providing a finished look. It fits gray enamel cooktops and helps make cleanup easier while protecting the area below the burner. What it does:

• Replaces a damaged, warped, or corroded surface burner pan
• Captures drips, spills and boiling-over liquids to protect the cooktop cavity
• Helps maintain even positioning of the surface heating element
• Restores appearance where the original pan is stained or chipped

• One gray surface burner pan (single pan as shown)

• High-level swap: lift out the cooktop or element as required, remove the old pan, and seat the new pan before reassembling
• Ensure the appliance is unplugged or power is shut off at the breaker before starting
• Handle edges carefully—enamel can chip if dropped; avoid using abrasive tools on the new pan
• If the element or mounting hardware was bent or damaged, inspect and replace those parts separately

This door gasket seals the refrigerator door to help keep cold air in and warm, humid air out—reducing frost build-up and helping the appliance run more efficiently. Fits where a full perimeter door seal is required. What it does:

• Creates an airtight seal around the refrigerator door to maintain consistent internal temperatures.
• Helps prevent warm air infiltration, moisture, and frost accumulation inside the compartment.
• Reduces energy waste caused by a failing or damaged door seal.
• Common symptoms of a bad seal: condensation at the door, frost on shelves, fluctuating temperatures, or higher energy use.

• Disconnect power to the appliance before attempting any service.
• Remove the old gasket carefully; replacement typically seats into the door channel around the full perimeter.
• Inspect and, if needed, adjust door alignment and hinge condition to ensure a proper seal.