Parts for Jenn-Air JMDFS24GS0: Control Panel Parts

Fastener screw

This wire harness connects and routes electrical signals between components so controls, motors and sensors receive power and communication. Replacing a damaged harness restores safe electrical continuity and reliable operation. What it does:

• Links control board, switches and motors with insulated wires and connector plugs
• Replaces frayed, burnt or broken wiring that can cause intermittent operation or failures
• Restores proper signal and power flow to affected appliance circuits
• Helps eliminate arcing, shorts or error codes caused by damaged wiring

• One complete wire harness assembly as shown

• High-level replacement only; disconnect power before servicing and follow appliance-specific wiring diagrams
• Handle connectors carefully to avoid bending pins; match connector orientations during reassembly
• If connectors or terminals are corroded, replace or clean per OEM guidance

This console is the outer control panel assembly that houses the dryer or washer controls and display, restoring a finished appearance and providing a secure mounting location for the user interface. Designed to match the original OEM fit and function. What it does:

• Replaces a cracked, faded, or damaged control panel shell to restore proper button and display alignment.
• Provides the mounting surface for user controls, buttons, and the display window so settings operate correctly.
• Helps protect internal control components from dust, moisture, and wear caused by regular use.
• Can resolve issues where physical damage prevents normal operation or makes controls difficult to access.

• One console (control panel assembly)

• Disconnect power (and water supply for washers) before starting any repair to avoid shock or injury.
• Remove outer cabinet/console trim as required to access mounting screws; handle the console carefully to avoid scratching the finish.
• Verify alignment of clips and screw holes before tightening; avoid overtightening to prevent cracking.
• If console contains electronic components, handle with ESD precautions and avoid contact with circuit boards or connectors unless replacing the full assembly.

This console is the exterior control panel housing that holds the appliance's buttons, knobs and display so you can select cycles and settings. It restores the control surface and keeps internal controls protected. What it does

• Replaces a cracked, warped or cosmetically damaged control panel housing
• Provides a stable mounting surface for buttons, knobs and the display assembly
• Helps keep moisture, grease and debris away from internal electronics
• Resolves issues with loose or misaligned controls caused by a damaged console

• Disconnect power (unplug or turn off breaker) before starting work.
• Handle edges carefully; plastic panels can have sharp or brittle areas.
• Remove trim and fasteners as required; support the console while disconnecting wiring to avoid strain.
• Transfer or reconnect components exactly as removed and test operation before reassembling fully.