Parts for International Dryer 30STG/MR: Controls And Coin Box Parts

This complete door main assembly replaces a damaged or worn washer door to restore proper sealing and reliable door operation. Designed to fit the original mounting points and finish for a factory-style replacement. What it does

• Replaces the washer's primary outer door assembly to restore a secure closure and proper appearance.
• Helps stop door-related leaks caused by cracked or warped door components.
• Restores proper engagement with the door latch/switch so the machine can start and run.
• Eliminates rattling or misalignment from a bent or damaged door.

• Disconnect power before beginning any repair to avoid shock or injury.
• Support the door during removal and installation to prevent dropping or damage.
• Basic hand tools (screwdriver, nut driver) are typically required; mounting hardware is often reused.

This door rim gasket seals the dryer door opening to help keep heat and air inside the drum for consistent drying performance. It replaces worn or damaged seals to reduce air leaks and improve efficiency. What it does:

• Creates a tight seal around the door rim to minimize heat and air loss during cycles
• Helps maintain proper drying temperatures and consistent cycle performance
• Reduces lint and moisture escaping into the cabinet and surrounding area
• Common symptom fix: worn, cracked, flattened, or torn gasket allowing air leaks or poor drying

• One door rim gasket

• Disconnect power (and gas if applicable) before any service
• Replace per the appliance service manual; remove door or front panel as needed to access the gasket channel
• Seat gasket evenly around the rim without over-stretching; verify proper fit and closure before returning to service
• Inspect adjacent door latch, hinge, and mounting surfaces and clean channel prior to installation