Parts for Frigidaire FGC6X9XESD: 02 - Cooktop Parts

This replacement burner pan restores the cooktop surface under a surface heating element, catching spills and providing a finished look. It fits gray enamel cooktops and helps make cleanup easier while protecting the area below the burner. What it does:

• Replaces a damaged, warped, or corroded surface burner pan
• Captures drips, spills and boiling-over liquids to protect the cooktop cavity
• Helps maintain even positioning of the surface heating element
• Restores appearance where the original pan is stained or chipped

• One gray surface burner pan (single pan as shown)

• High-level swap: lift out the cooktop or element as required, remove the old pan, and seat the new pan before reassembling
• Ensure the appliance is unplugged or power is shut off at the breaker before starting
• Handle edges carefully—enamel can chip if dropped; avoid using abrasive tools on the new pan
• If the element or mounting hardware was bent or damaged, inspect and replace those parts separately

Color: Black.

This door gasket seals the refrigerator door to help keep cold air in and warm, humid air out—reducing frost build-up and helping the appliance run more efficiently. Fits where a full perimeter door seal is required. What it does:

• Creates an airtight seal around the refrigerator door to maintain consistent internal temperatures.
• Helps prevent warm air infiltration, moisture, and frost accumulation inside the compartment.
• Reduces energy waste caused by a failing or damaged door seal.
• Common symptoms of a bad seal: condensation at the door, frost on shelves, fluctuating temperatures, or higher energy use.

• Disconnect power to the appliance before attempting any service.
• Remove the old gasket carefully; replacement typically seats into the door channel around the full perimeter.
• Inspect and, if needed, adjust door alignment and hinge condition to ensure a proper seal.

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts