Parts for Jenn-Air JIS1450DP2: Cooktop Parts

Replacement mounting screw for securing range panels, brackets, and internal components. Replace missing, stripped, or rusted screws to restore fit.

Cracked or damaged cooktop surface? This glass cooktop assembly restores a smooth, heat-resistant cooking area and improves safety on your range.

Burner won't heat or heats unevenly? This hot surface element restores proper heating to your electric range cooktop. Direct replacement takes 15-20 minutes.

Fix uneven heating or a burner that won't heat up. This hotplate restores proper heat transfer to cookware on your electric range cooktop surface.

Range not heating or display not working? This electronic control board manages oven functions and temperatures. Moderate difficulty repair for experienced DIYers.

Replace missing or stripped screws for your range anti-tip bracket. This 2-piece hardware set secures the bracket to the wall or floor for stability.

Fix a washer agitator that slips or won't turn. This anchor tip secures the agitator to the drive shaft, restoring proper rotation during wash cycles.

Support bracket for electric and gas ranges. Replaces broken, bent, or missing brackets that secure range components. Direct fit replacement hardware.

Replaces a damaged, cracked, or missing trim vent grille on your range. This exterior trim piece covers the vent opening to restore appearance.

Control panel end cap for electric and gas ranges. Replaces cracked, broken, or missing decorative trim pieces on the control panel edge. Cosmetic part.

Decorative end cap panel that installs on the side of your range. Replace this cosmetic trim piece if it's cracked, chipped, discolored, or missing.

Fix unresponsive buttons or blank displays with a new control panel. Houses all cooking function controls and displays for your electric range.

Secures range components to cabinet or chassis. Replace this bracket if cracked, broken, or missing to restore proper alignment and reduce vibration.

Range not responding to controls or display blank? This electronic control board manages timing, cycles, and the interface. Restores reliable operation.

Mounting screw secures panels, brackets, and trim to the appliance frame. Replace if screw is stripped, missing, or damaged to restore secure fastening.

Support bracket for electric and gas ranges. Secures internal components in place. Replace if bracket is bent, cracked, broken, or missing.

Replace cracked or missing rubber bumpers on your range. This protective pad cushions and stabilizes components, typically securing with a screw.

Replace your range door gasket to restore a tight seal and prevent heat loss. Fits worn or cracked seals so your oven door closes properly. Confirm fit.

If your range won't heat or displays electrical errors, a faulty wire harness may be the cause. This connector assembly restores power routing between components.

Wire harness for electric ranges. Connects terminal block to control board. Replace if wires are damaged, frayed, or connections are loose or broken.

Fix F2:E0 error codes with this range keypad wire harness. Connects keypad to control board for proper communication. Moderate DIY repair task.