How to Troubleshoot & Replace Frigidaire AP2552241 / 316101514 Overlay - Clock (Control Panel)

Google was my best friend! Found a couple of YOU TUBE videos pertinent to my issue. Very first thing- UNPLUGGED THE RANGE! I took the back off my stove first, very simple just removed 6 screws. Then, to get to the overlay, I had to remove the front panel with the control knobs (2 screws, located under the control knobs, one on each side). There were two more screws directly under the overlay (needed my socket wrench for these). Once those were out, overlay came out easily. Peeled off old overlay, then removed back and affixed new one. Easily done, just be sure to line up. Don't forget to remove the protective film on the front of the new one, also. Put overlay back in place, replaced those two screws, then replaced the front panel and the two screws under the knobs. Replaced the back panel, plugged it in and was good as new! 

We unplugged the stove, unscrewed the assembly on the backboard, unpeeled the damaged overlay, cleaned the sticky residue, reapplied the new overlay, then reassembled the backboard. We had to repeat the reassembly after realizing that the oven vent fan had not been properly replaced facing the stove top after the first effort. We had watched a YouTube movie about the procedure before attempting it. We did have the square-notch screw head needed for this job. 

Changed the control module and all is well, the oven works timer works nothing is shutting down and moma is happy. 

Replaced the overlay. 

Replace with ordered part. 

Bought the oven igniter