How to Troubleshoot & Replace Ge AP2044374 / WE25X60 Slide Kit

I did myself it was easy to fix it.. 

1st time user of Appliancepartspros.com. My dryer belt broke one night. Never had a dryer apart before but with your video help I took it apart in no time and confirmed my broken belt. Went on your web site, plugged in my model#, found my belt and also ordered a bearing and bushing kit as well. FAST shipping !! I had my parts from your warehouse in 2 days. And the replacement parts you sent me weren't cheep Chinese garbage, they were ACTUAL G.E. made in USA replacement parts. Needless to say everything went back together as it should. For less than 50 bucks and 45 minutes of my time, I have a dryer good as new again.Thank you. 

Instlalled slide kit and belt ,new lint screen. 

Used small star drive (torx) and 5/16" socket... Removed screws securing the front of the top panel, then hinged back. Removed two inside bolts to remove the front panel, that has slots that rest on a screw at the bottom...they just slip off the the bottom after the top screws are removed. The drum lifts forward and up, because the belt was broken, so nothing was holding it down. I then replaced the slides with a socket wrench, because they are up front and easy to get to with the drum off. I looped the drive belt around the drum, and placed the drum back in place. On my model I had to remove the small back panel to access the belt pulley drive and belt-tension pulley. I looped the belt around the motor drive, then ran the belt around the tension pulley. Closed everything up...started the dryer... runs smooth and quieter than before. 

Great parts and good service is what it's all about. Took me about a hour to repair. Removed drum installed rear bearing and mounted front slides on both front panel assembly. Wasn't Hard to do at all. Dryer is so quite now you can't even tell it's running. Thanks for the great service. 

I found my drum slides were worn out. I purchased a new set from you. And with the included instruction had them replaced in 5 minutes. My wife is happy so I get to be happy. THANKS . 

Replaced parts 

Prayer, bubblegum, duct tape, a hammer, and replacement parts 

I read a few reviews and found out the rear bearing , ordered a bearing repair kit , when it arrived I watched a repair video on my model and replaced the bearing and the slides on the front where the drum sit on the front of the dryer and that fixed the problem. Had a little problem fitting screws in the drum to the bearing sleeve ,but with a couple small screwdrivers aligned the three holes and it worked. Like new dryer now hope it last another 20 yrs Thanks Appliance Pros. 

Ordered new slides. Very easy to change. Perfect drum alignment. No more squeek or bouncing. Use the grease included to lube the plastic slide and the the felt pad underneath it.