Michael T Washington , UT October 01, 2018 Appliance: Magic Chef Refrigerator MCBR1020W The compressor would not run, it was making a clicking noise about every 30 seconds I replaced both the Ptc starter or the motor protector. I found a post online through a Google search that said it was likely either one of those parts. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Dennis S Sun City , CA September 27, 2016 Appliance: Model MAGIC CHEF MCBR1020W My secondary refrigerator stopped cooling I googled it. I went on line and found a repair video of a similar refrigerator and found that quite often one little part, start relay, prevents the compressor from kicking on. I located the part in my unit, removed and ordered a new one. When the new part arrived it was fixed in minutes. Going on line and educating myself, an hour or two. Accomplishing the repair, less than an hour, finding the part, removing, ordering new and reinstallation. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
William C Converse , TX February 11, 2019 Appliance: Model SALL MAGIC CHEF REFRIG. Compressor failed to start. Checked run capacitor, start relay all good. Problem with heat overload sensor, open contacts. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Teresa F Buda , TX February 02, 2020 Stopped My husband installed the Ptc starter that I ordered. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Michael H Saint Petersburg , FL April 14, 2019 Appliance: Model MAGIC CHEF REFRIGERATOR MCBR1020W Fans running but not cooling. The compressor relay would click but the compressor would not start It sounded like the PTC starter was the problem, but I decided to get a defrost timer as well in case it was bad. The timer is simple to replace. Remove a few screws, disconnect the wires, pop them on the new timer, put the screws back in, and done. I hadn't read any hints about installing the starter. It was easy to put in once I figured out how it attached - two slide-on pins. I used a screwdriver to wiggle the old one off, swap out the wires to the new one and slide it on the pins - the only difficulty is getting your hands into a small space. A flashlight is very helpful. The frig worked fine after I replaced the starter. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Frank W Kutztown , PA August 14, 2017 Appliance: Model MCBR1020W MAGIC CHEF Refrigerator compressor wouldn't start. Replaced the solid state starter, after following the troubleshooting guidance on the site. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Secharran R Richmond Hill , NY July 14, 2017 Appliance: Magic Chef Refrigerator MCBR1020W The compressor was not coming on. I noticed that the compressor was not coming on. I search the internet for the issues I was having and founded that ts most likely because of a bad starter relay. This is the Switch that turns the compressor on. Also please note that Prior to this faulty Compressor switch my fridge was extremely cold without any issues. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Adjustable Wrench, Screwdrivers
Stephen K San Antonio , TX January 02, 2017 Magic chef refer not cooling New start relay. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Roger B Gilbert , SC July 23, 2016 Appliance: Model MAGIC CHEF FRIDGE. My beer fridge died Traced the trouble to the compressor starter. Entered the model number on line. Found wiring diagram and part number. Entered part number on line. Appliance parts pros popped up and 2 days later my beer is cold.... Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers