Christine M Du Quoin , IL March 04, 2016 Appliance: Samsung Washer WF448AAW/XAA Wash cycle would not drain intermittently Each time it happened I would remove the front cover and test pump which would ohm out at 14-16 ohms and also would always run when tested. I left the top off and hooked meter into the purple wire at main circuit board that goes to pump and the other lead to ground. Ran a load and was able to see when acting up no power was coming from board. Installation was very easy diagnosis was much harder Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
Jason U Los Angeles , CA December 27, 2014 Power surge burnt control board in washer Ordered new control board to replace burnt board. Opened up washer, disconnected old board and connected new board, then put washer back together. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Garrett A Desloge , MO January 23, 2017 The main power control board went out I was able to find an Appliance Parts Pros YouTube tutorial video that showed me how to remove the power control board. After watching the video it was simple, I removed a few screws, unplugged the wires from the PCB, then I plugged in the new PCB, and put the screws back in. It was as easy as that. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Alton J Catawba , NC January 12, 2016 Appliance: Samsung Washer WF448AAW/XAA Machine would not pump water from drum after wash cycle Installed new PCB reassembled machine and powered up. All cycles work properly. The machine pumps out the water. It would be helpful to keep up with where the screws were removed from so they could be replaced in the proper holes. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Cornelius I Lawrenceville , GA November 03, 2015 Intermittent door sensor & power issues Verified the door sensor wasn't the culprit by bypassing it, which confirmed it wasn't the issue. The main PCB was exactly the issue, and replacing it was a breeze. I will say that AppliancePartsPros have really come through! The local suppliers were saying 2-3 weeks out. Appliance parts Pros had it to my door the next day! Thank you guys. Great service. Quickest shipping ever. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Herschel H Daleville , AL March 30, 2015 Samsung washer had no power Replaced main PCB Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers