Ralph F Sanger , CA July 13, 2016 Display was flicking display went out and a humming coming from inside of dryer Replaced power board. Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Leslie S Oxford , MI January 22, 2017 Appliance: Maytag Gas Dryer MDG9700AWW Dryer would not run Installed igniter but turned out not to be the problem. Control board hummed, replaced it and now it works. It did turn on, I have to run some clothes in it to make sure that the control board works under load. Read More... 10 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Dikran S Valley Glen , CA February 07, 2020 Appliance: Maytag Gas Dryer MDG9700AWW Drier would not turn on you could hear it hum but display wouldn't light up I replaced the Control board as mentioned at Appliance Parts Pros.com repair section problem and answer. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Perry H Mccall , ID April 25, 2019 The dryer simply stopped operating when it completed a drying cycle there were no lights on the front panel and there was a humming noise whenever it was plugged in I researched the issue for my dryer on the internet. AppliancePartsPros came up on the search. I researched the issue a bit further on their website. The symptoms that my dryer exhibited were the same as described on their website for others. I ordered the recommended replacement control board and the dryer began working again as soon as the part was installed. The installation was easy, straight forward and very quick. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Jaime H Pearsall , TX October 04, 2015 Beeping noise on dryer no lights on panel Replace with new control board . And now working like new. Easy and simple to remove and install new part. Very happy that I found appliancepartspros.com thanks Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers
James W New Orleans , LA February 10, 2019 Bad circuit board From the time that was discovered, order the part and received the part was a total of 3 days and made my wife very happy Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Bruce O Santa Barbara , CA January 21, 2018 Appliance: Maytag Gas Dryer MDG9700AWW Dryer only made a buzzing/humming sound advice on appliance pros site stated it would be the control board ordered a control board and installed it in less than 10 min now dryer works like a champ! Basic remove and replace. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Eric K Berlin Heights , OH November 09, 2017 Control board was bad. Replaced it. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers