Christopher A North Bellmore , NY November 07, 2016 Gas burner would not ignite Like many others, the screws holding in this burner assembly were completely ceased. I had to drill them out, and it was difficult. Below the assembly was so rusted, there is nothing left to screw into. Great parts, perfect fit, poor design on Jenn-Air's part. An obvious flaw and without replacing the sub parts that this assembly to screws into there is no way to hold down this part. Great parts, great service, rapid delivery....bad stove....bad bad stove with some major design flaws. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Alicia C Elizabeth , NJ January 01, 2017 Burners would not ignite Replaced burned. Perfect fir installed in about 20 minutes all 4 burners. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Dusty D Hanford , CA December 12, 2016 Stove would not ignight Replaced all burners Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers, Wrench Set
James O Ridgefield Park , NJ September 24, 2016 Appliance: Maytag 30" Gas Slide-In JGS8860BDP17 Ignitor wasnt working Ignitor wasnt working after disassebly I realised the ignitor was cracked and rusted as well. Replacing the burner and ignitor assembly fixed eveyrthing and took about 5 minutes Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Bonnie G Wharton , NJ May 06, 2014 Burner was making a clicking sound Replaced burner. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers