John M New Port Richey , FL October 02, 2016 Needed a new dispenser lid Bought a new one Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Darin A Hillsboro , OR August 08, 2016 Noisy dryer and molding front seal on my front load washer Ordered the parts, watched the video and went to work on both. It was all very easy! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers
Milton C Portland , OR July 16, 2016 Broken part Ordered it, had it shipped, easy install... Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Robert C Rathdrum , ID February 28, 2016 Dispenser lid on my maytag washer was broken Ordered a new lid and installed it. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Gary D El Dorado Hills , CA November 16, 2015 Dispenser lid had been broken off maytag neptune washer Removed the dispenser bezel by removing four Philips screws and gently pulling the dispenser bezel away from the washer. It was very easy to remove. I inserted the hinge pins in their proper places (since the hinge pins are two different sizes, lining up the new dispenser lid with the dispenser bezel will indicate the proper location for the hinge pins). To get the new dispenser lid onto the dispenser bezel, place one end of the dispenser lid on one of the hinge pins and then slightly bend the dispenser lid in order to slide it over the other hinge pin. Place the dispenser bezel in place and lightly tighten the Philips screws to secure; do not over tighten. I did all of this while the washer was in use. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Ron R Greenville , SC August 31, 2015 Appliance: Maytag Washer- Horizontal Axis MAH5500AWW Dispenser lid broke off washing machine hinge pins slots rotted away Very simple, after receiving new lid and hinge pins, placed the top hinge pin in the lid and set the lid back into washing machine frame. Lined the lid up and with the lid flap open, inserted the bottom hinge pin and pressed bottom hinge pin firmly in place. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
David J Enid , OK June 12, 2015 Lost the lid when moving to the detergent cover Was a really easy fix. just put the new pins in the lid . Had to bend the lid slightly and it locked right in. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Maria F Springfield , MO May 23, 2015 Appliance: Maytag Washer- Horizontal Axis MAH3000AWW Same problem with all of the older neptunes sounded like a jet airplane when spinning out! New bearings in the outer drum. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set, Wrench Set
Cesar R Belstville , MD April 10, 2015 Appliance: Maytag Washer- Horizontal Axis MAH4000AWW The soap dispenser lid in our maytag washer was broken and missing the long pin This was a 5-minute job: got the old dispenser lid out, took the new one and added the pins and re-inserted the new lid. Done! Now we are happy with our washer again. Thank you. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes