Installed a new motor. Emptied the freezer side first, then pulled the plug to turn off power. Next removed the top left vent cover, it snaps out. This exposes the only 1/4" screw holding the top plastic cover. Removed the screw and popped out the plastic cover which covers the top half of the back of the freezer. this exposes the top two 1/4" screws, the two 1/4" screws at the bottom are not hidden. Removed the four screws and popped out the metal cover which covers the bottom half of the freezer. there are four clips on this panel that hold it in place. Note, one of my clips would not stay in place when I put the cover back on. Now the motor is exposed, disconnect the two wires by lifting the little tab on the connector and pull connectors apart. Next remove the ground (green wire) by pulling the connector from the motor If you can see the connector slide the fan assembly out of its slot and flip it over. Now the fan is free of the wires squeeze the plastic clip and push up a little to free it on both sides. The motor will be free of the motor mount. Next pull the fan off from the motor. There are two clear rubber sleeves that hold the motor in the mount remove them from the motor and place on the new motor. now reassemble the everything in reverse the way you dissembled.