Replaced the Control board after determine it was the cause of the failure. Since I had the unit out of of it's place in the laundry room (quite a Task), I decided to replace the belt and pulley as the dryer is now 15 years old. Belt was dry.and pulley was worn. Replacement went fine. The washer that came with the pulley was not thick enough so I used the original one on the inside of the shaft and the new one on the outside which minimized the amount of walking on the shaft the pulley did so that worked out fine. I lubed the shaft with a small amount of lithium grease. After re-assembly the dryer runs very well and is somewhat quieter. The parts sent seem to be good quality and fit perfectly, They will hopefully last until the dryer reaches EOL.