Removed top to access screws to remove front panels. Removed the door switch. Those screws and the detergent tray screws are stainless steel. Make sure you use them when you reassemble it. Placed 2x4 under feet to access screws at bottom of the front panel, slid out the detergent tray(there is a push-button inside the tray at the end of it). Carefully removed the plastic control panel and laid it on top without disconnecting the wire. Removed remaining screws and bellows springs, and bellow. That was actually easy. I lubed the channel that clips over the lip and wiped off any exes. Starting at 12:00 position wiggled in place. That was easy once I got the technique down. I would have given the job a 1 rating as a challenge from 1 to 5 at this point, but here is where it gets hard. The tool included to hold the inner bellows spring in place while stretching it around the bellows must be made for a different model I needed a second pair of hands to stretch around. The part itself was a genuine Frigidaire replacement, though probably fits several models.