I bought a new belt and a rear bearing kit. The bearing kit consist of two components: 1 attaches to the back of the drum and installed fairly easily. The second component attaches to the rear wall of the dryer and necessitated removing the heating elements. The videos supplied online were very helpful and easy to follow. Unfortunately, the second component came with screws that didn’t fit the part to be attached. The holes were 5/32 in diameter and the coarse-threaded screws provided would not tap into the holes. Thinking the holes were too small I enlarged one to 3/16 but that was too big and the screw wouldn’t tighten. I wasted a lot of time trying to get the new part to fit bit in the end I reused the old rear component. Dryer works great though!