Do-It-Yourself Story

After reviewing the EXCELLANT Repair Videos ( Performed by MATT ), I took the dryer apart and found that the Right side ROLLER had worn and broken apart. I also found the Shaft ( Drum Roller Axle ) Also had worn badly and had to be replaced. (The LEFT side was OK, But I replaced that ROLLER only as well, the shaft was good) I also replaced the DRUM BELT which showed signs of cracking AND it;s BELT TENSION PULLEY. The most difficult issues were: 1). Replacing the Roller Axle shaft. VERY LITTLE ROOM to tighten nut with a wrench! ( I had to use a short length wrench ), difficult to make tight ). 2). Re-threading the BELT around the Belt Tension Pulley and Motor shaft! You must do it by FEEL because you are REACHING IN to do it with NO VISUAL VIEW. ( The DRUM is blocking your view ). 3). Good IDEA to color mark ( with felt pen ) which HOLES to LINE UP when RE-ASSEMBLING with screws. Will save you a little time! VERY IMPORTANT to take the TIME to WATCH the REPAIR VIDEO!! I watched it at least 6 times (for details) AND had my Laptop next to me as I went step by step during the repair! VERY HELPFUL! It DID take EXTRA time to VACUUM & CLEAN the LINT that was EVERYWHERE INSIDE! Be prepared to spend TIME CLEANING as well! TOTAL job took me about 2 1/2 HOURS!