Not having an ohm meter I ordered the thermal fuse and the heating coil, since they are the top 2 reasons for no heat. I had to address the repairs from the front, which was very difficult. The wires connecting the fuse were so tight, I had trouble pulling the wires off to replace the fuse. I was only able to disconnect the wires by laying the dryer down on its back side in order to get a good grip. After replacing the fuse, I started on the heating coil. After taking off a screw holding the heater bracket, I needed a pair of pliers to pull out the bracket. It took all I had to pull out the bracket. After removing the coil, I saw where the coil was broke, which made me happy that I discovered the reason it did not heat. Sliding in the new coil bracket was not easy, I needed my rubber hammer to gently tap it in place. All is good now