Ordered new latch based on schematic on app.com. While the latch replacement was a 2 minute fix I found that the broken off piece was locked into the female end on the rim of the washer. I removed that (2 screws) then needed to unplug the housing and then release the box that held the receiver. I found it to be a spring loaded catch that once I opened it- the tip of the latch came out. The housing that held the female receiver was plastic and had four small pressure catches that once released opened to the latch, easy. The you simply put back together, replace the plug and screw it all back into the side/front? Once you turn on the washer and close the door the latch is accepted by the female side. Note this will not happen until the washer is on and the door is closed. All in perhaps 15 minutes work after my remedial mechanical mind thought it through.