After much trial and error I located and corrected the problem. The motor was operational as I could see it turn but I could not see if the auger was turning. I wedged a toothpick to close the door switch and operate the dispenser lever. I determined the auger was not turning. Out of curiosity I removed the bin and turned the motor by hand. Everything seemed okay until I operated the motor and held the auger drive, the forked piece, and that stayed still while the motor turned. In other words the forked piece stopped turning when I held it but not the motor shaft. Solution, tighten the forked auger dispenser. I never saw this solution when I check for ice cube repair problems.
When the ice cube dispenser fails to dispense ice cube check the forked piece for tightness even if the motor runs. In regards to how long the project took should read how long did it take to trouble shoot the problem. Repairs took seconds once problem was found.