Do-It-Yourself Story

I ordered the part and followed a fantastic video. However, I took the molding and unsnapped the molding and found that the part called gasket holder (AppliancePartsPros told what it was called) The part came quickly so I went through the process again but when I got to the rubber/ plastic molding I found one piece around the door. I decided to cut it at the bottom corner and slid it up out of the slot and piped out the two clips holding it to the door. I slid the gasket into the bed holder making sure that the two springs were one in the outside and one side was on the underside. I snapped the two gasket holder plastic clips into the door and replaced the plastic molding. It was a breeze that took two screwdrivers and a push from the palm of my hand,15 minutes total time but an hour thinking about it. The only issue was the gasket slit at the bottom corner - I did not tape it or glue - it seemed to be sealed so I did nothing and it works great