I was able to remove the cover at the top of the oven and then lift the door off. I put the door on a flat surface, outside face down. With a thin blade screwdriver, I was able to pry the inside bezel off, starting at the handle side. I then removed two Philip's head screws holding the panel with the metal mesh. By working from the handle side again, I was able to pry the panel up, releasing the locking tabs as I worked towards the hinge side. Once it was out, the two Philip's head screws that held the remains of the handle were exposed. I removed them. I lifted the door and placed the new handle in position. I attached it with the two screws that came with the new handle. I popped the inside panel back in, starting it at the hinge side. I replaced the two screws I had taken out earlier and then popped the bezel back into place.