After reading online, I figured I might have a bad auger motor since it would not turn when the ice arm was depressed. I decided to take a look at the switch before I ordered anything. After removing the two screws that hold the feont plate on and removing it, I was able to see that the switch was loose. After further review, I could see that the plastic mounting bracket had broken. I looked up the part online and ordered it. To install you have to disconnect a few connectors and replace the bracket and then replug them in. Be careful to make sure they all go back in the same spot. I took some pictures to help with this. When I was done everything worked fine. For a temporary fix, I tie wrapped the switch in place.