I pulled the transmission and took the top cover off and used the video instruction to replace the old defective parts, put in new oil and put an epoxy seal around the edge and put the cover back on, all in all, it was quite simple, word of advice is BE CERTAIN the part is properly installed because when I first put it in it seemed alright, but I watched the video one more time and realized it was in wrong. I also replaced the clutch, this was a bit tricky because there is an odd clip that curls around and is not easily put in place, and when I double-checked my work I realized it was not properly seated, the plastic piece that snaps in the center of the clutch housing has small tabs that come up and the clip needed to be down in tighter and be inserted and seated inside the metal tabs on the clutch housing, I also have a need for seal replacement in the spin tube inside the basket drive, so I decided to replace the basket drive because I will save money overpaying for a pro to come and replace the seals for me, and because of the difficulty level I did not want to replace the seals myself and risk doing more harm than good.