I ordered the ice door motor. Installation was pretty straightforward. Removed the water tray, then the two screws to the cover. Unplugged the two wires from their harness, next the two screws that hold on the assembly, and then the two screws that held on the motor. I wish I had known that the door would tighten up to the chute on its own as I took off the motor a second time because the door did not appear to mesh up tight to the discharge chute. I finally just put it together anyway. I determined the the motor tightened the door against the chute after dispensing ice. No problems, works great. And the wife is happy as that makes everyone happy.