Ordered part too close to Christmas so did not receive next day. The wires are not connected to the solenoids so make sure you keep old valve assembly and compare. Fairly easy to connect since new part wires match old wires. First step of course is unplug the washer from power, turn off water valves and disconnect hoses. Have a towel to soak up any water in hoses. Front of machine needs to be forced up and tilted back. Pull all hoses off old valve. Tilt top back down. There are 3 screws in the back of the washer that release the control panel. There are 2 screws that hold the valve assembly in place and 1 screw to secure the ground wire. Keep these as the new valve does not have replacement screws. Install new valve assembly and screw in place and ground wire. Push hoses back onto new valve. Secure top of washer. Screw water lines on, make sure hot to hot cold to cold. Turn water on and plug back in for power. That's it, works better than new.