Remove the oven door from the oven. Partially open the door & flip up the latch at each hinge then lift the door from the oven.
Lay the door down on a soft surface with the interior side facing up.
Only four screws secure the outer panel to the door. Two screws are on the top edge and two secure the clamps on the bottom edge. Do not remove the screws in the oven-facing side of the door.
Slide the interior part of the door toward the handle (upward) while lifting.
Remove the four screws that secure the handle to the door. Pay attention to how the metal plates are aligned to the old panel and notice how loose they are and that they secure the handle to glass. Do not over tighten these screws.
Remove the protective plastic film from the new outer door panel.
Place the old plates around the holes on the new panel. Gently secure the old handle to the new panel. Turn the screws until the head contacts the glass. Do not tighten.
Place the inner door on the outer panel sliding it down onto the clips.
Check that the screw holes in the handle clips are aligned with the holes in the inner door. If not remove the inner door and adjust the clips. Do not force the clips.
Tighten the two screws at the top & secure the clips and screws at the bottom.
Align the hinges to the holes in the oven and insert. Push the oven door down to expose the latches. Flip the latches to secure the door to the oven.